alles over je Palm Treo smartphone of PalmOS pda
|
Registreer | FAQ | Ledenlijst | Kalender | Berichten van vandaag | Zoeken |
#1
|
||||
|
||||
Garmin Etrex -- Kabel --- Handspring Visor
Als ik een Garmin Etrex via een kabel aan de Visor verbind, kan ik mbv bv TomTom route kijken waar ik zit. Wat volgens mij niet mogelijk is (is dit een Visor probleem?) is het uploaden van waypoints vanaf de Visor naar de Etrex. Of heeft iemand (liefst ibv Visor) hier andere ervaringen mee?
Groet, M@rt
__________________
When I see the price that you pay I don't wanna grow up |
#2
|
||||
|
||||
Het kan misschien zijn dat je kabel niet helemaal compatible is? Of je software het gewoon niet kan?
|
#3
|
||||
|
||||
Ik heb de Etrex en de kabel nog niet, ik las dit op:
http://www.pc-mobile.net/gpsnote1.htm ik meen mij te herinneren dat er in een andere thread stond dat dit met een Palm wel kon. M@rt
__________________
When I see the price that you pay I don't wanna grow up |
#4
|
||||
|
||||
Ah op die manier. Nou als ze dat daar zeggen, dan menen ze dat ook. Ze geven heel expliciet aan wat er wel en niet met de kabels kan. Die visor zal ook wel een level convertor nodig hebben om een RS232 aansluiting te kunnen maken. Dat betekend dat ze per geconverteerde lijn kosten moeten maken. Als ze dus een lijntje weglaten (van de Visor naar de GPS) dan scheelt dat dus kosten. Suf natuurlijk, want maak dan gewoon een iets duurdere kabel, maar ja.
Dan moet je misschien toch een andere kabel zoeken. |
#5
|
||||
|
||||
Morgen ga ik naar Correct.
Als iemand nog nieuws heeft over een Visorkabeltje hou ik mij aanbevolen. M@rt
__________________
When I see the price that you pay I don't wanna grow up |
#6
|
||||
|
||||
#7
|
||||
|
||||
__________________
When I see the price that you pay I don't wanna grow up |
#8
|
||||
|
||||
Dat was inderdaad de site van die "meneer". Maar daar vragen ze dus 89 euro voor een "PDA" kabel. Of dat ook een Visor kan zijn weet ik dan niet.
|
#9
|
||||
|
||||
Ik heb de Garmin gekocht bij Correct.
Was wel een tegenvaller dat de pc-kabel los gekocht moest worden voor 60!!!!!!! Euro. Die heb ik laten schieten, ik koop de kabels wel bij PC-mobile... Groet, M@rt
__________________
When I see the price that you pay I don't wanna grow up |
#10
|
||||
|
||||
Hoi DeMart
Ik heb een wat ouder type garmin, de garmin 12. Doet het prima in combinatie met de palm. Ook in tomtom kun je zien waar je zit. Ik een tijd terug zelf een pc kabel gemaakt omdat ook ik de standaard kabels veel te duur vond. Heb de garmin connector besteld bij pfrank (zie link bij patrick) werkte prima. is niet zo heel moeilijk om je eigen kabel in elkaar te solderen. Heb meteen wat intelligentie in de kabel gestopt zodat ik hem kan koppelen met palm, pc, mac en de garmin van externe voeding kan voorzien. Volgende pagina geeft veel informatie over gebruik van palm in combinatie met GPS. http://celia.mehaffey.com/dale/pilotgps.htm Er is ook een apart lijstje met software specifiek voor Garmin. Ben zelf erg tevreden over het programma GPilotS om routes, tracklogs en waypoints uit te wisselen met de PGS. veel plezier met je nieuwe speeljte Groeten, Peter |
#11
|
||||
|
||||
Hier nog een stukje over visor kabelverbinding. Komt van bovengenoemde site:
http://celia.mehaffey.com/dale/phardware.htm#usb Citaat:
USB discussion
The handspring, the Sony CLIE, and the new Palm M500 series units feature a USB hotsync. Standard gps devices cannot be used directly with these units via USB. Sony and Palm USB units also have a built in serial port in the connector. Handspring does have a serial sync adapter that some have adapted to hook to a gps. Unfortunately the adapter taps power from the serial port on the pc and cannot be used directly with the visor. You would need to design your own power supply or battery connection to make this work. Handspring modification - I have not tried the following steps myself and cannot guarantee they will work. This may void your warranty so proceed at your own risk. You need a source of power from about 5 Volts to 12 volts. (There is a isolation diode and a 3.9 volt zener in the cradle.) You need to include a series resistor of at least 120 ohms and perhaps as high as 390 depending on the source voltage to limit the current. One choice is to just use a 9V battery. Whatever your choice you need to wire the negative lead to pin 5 of the DE9 connector and positive through the series resistor to pin 7, the RTS line. Of course you still need data, 3 to 2 and 2 to 3, and a data ground also on pin 5. This information is from Curtis Mills. He made a 9 pin to 9pin adapter cable for his unit, combining gender changes, null modem, and power source. He taped a 9V battery to the cable. Thanks for the information, Curtis. Check the discussion of this topic on PocketAprs. The serial data itself is directly available from the HandSpring unit. It is not the correct polarity and only has a 3V swing but some have had success wiring it directly to gps units. A source of data is Handspring Visor Page. This solution has inverter hardware but does not need the serial cradle. Also check here for more information on this topic. Click on any of the .txt files to get started. You might also check ATL, however they have a minimum price so it would be good to form a pool of buyers. Groeten, Peter |
#12
|
||||
|
||||
Dank je Peter,
Maar ik had in de tussentijd de kabel voor PC en Visor via PC mobile besteld. Kost welliswaar een dollar of 40 maar dat is beduidend minder dan alleen een PC kabel voor 60 Euro... Helaas gaf de Garmin GPS 's avonds na aanschaf al de geest. Aangezien ik de dag er op naar mijn vakantiebestemming ging, kon ik hem nog niet omruilen. Dat gaat morgen gebeuren. Kabels liggen op het postkantoor, dus het spelen kan volgende week beginnen! M@rt
__________________
When I see the price that you pay I don't wanna grow up |
#13
|
||||
|
||||
Kabels van PC mobile heb ik maandag jl opgehaald.
De Visor (Prism) met TomTom werkt perfect met de Garmin! Kent iemand software om routes op de palm op te slaan? Groet, M@rt
__________________
When I see the price that you pay I don't wanna grow up |
#14
|
||||
|
||||
Met routes opslaan bedoel je "tracks" van de GPS? Dan kun je bijvoorbeeld Tracker (met kaartjes) van GPS Pilot of Cetus (gratis) nemen.
|
#15
|
||||
|
||||
Dank je Patrick, ga gelijk op palmgear kijken!
M@rt
__________________
When I see the price that you pay I don't wanna grow up |
#16
|
||||
|
||||
De links zijn:
http://www.gpspilot.com/Tracker.htm http://www.cetusgps.dk/ Er staat overigens wel meer infor in het forum hierover (denk ik). |