Bluetooth kaart verbinden met Nokia 6310

[N@gel]

Hieronder een beschrijving hoe je de blauwe tand kaart verbind met de Nokia6310. Dit schijnt ook te werken met andere Nokia modellen.

Het probleem met de standaard handleiding is dat je de twee niet gepaard krijgt. Met deze beschrijving lukt het.

De beschrijving komt van het Nokia bluetooth forum:

First stage is to set up for pairing. The secret here is to force
the Nokia 6310 to accept the Palm for pairing and enter the passkey
on the phone first. This is not what the instructions with the Palm
SDIO card describe but it certainly worked with my early generation
Nokia 6310 (software: v 04.10).

On Nokia 6310
Bluetooth = off
Search for audio accessries = don't bother!
View active device = none!
View paired devices = none!
Bluetooth settings - My phone's visibility = Shown to all
Bluetooth settings - name of phone = e.g. Nokia GC (anything you
want - I just used my initials to identify this as my phone)
Switch phone off
Switch phone on (this should reset the phone)
Select Bluetooth = on


On Palm M505
Place the SDIO Bluetooth Card into Palm
Install BT drivers (if you have not already done so)
Go to Preferences - Bluetooth
Bluetooth = on
Device name = Palm GC (again anything you want to call your device)
Allow Device to be discovered = yes
Goto preferences - Connection
New
Name = e.g. BT to Nokia 6310
Connect to = Phone
Via = Bluetooth
Model = Standard GSM
Device = tap to find
When found select 'Nokia GC'
Do you want to add Nokia GC to your trusted device list = no
OK
Goto preferences - Phone
Connection = BT to Nokia 6310
Test

You have to be quite fast now to enter the passkeys otherwise you
have to start the procedure again!

On Nokia 6310
When Phone reacts accept the connection!
Enter the passkey = e.g. 0123 (any number you want but do remember
it!)
Select

On Palm M505
When Palm reacts enter the passkey = 0123 (same number as above)
Add connection to the trusted devices list
OK
Goto Preferences - Bluetooth
tap Trusted Devices (you should see 'Nokia GC' at the top of the
list - check Details if you want)

On Nokia 6310
Check the menu of Bluetooth
View paired devices = Palm GC

The devices are now paired and you will not have to enter the passkey
again when they connect.

OK so far so good but there is still another step if you want to be
able to connect to Internet or e-mail. It does seem that the Palm
driver supplied has to be overidden as below

On Palm m505
Goto Preferences - Connection
Select the 'BT to Nokia 6310'
tap Edit
Change Connect to : from Phone to Modem (yes Modem!)
Via : Bluetooth
Device: Nokia GC (should still be shown)
Dialing: Touch Tone (default setting)
Volume: Low (default setting)
tap Details
Change Init String to ATZ (you may find a very long string here but I
guess this comes from the Palm driver settings)
tap OK
tap OK
Goto Preferences - Network
the only change to an existing profile is to change Connection to 'BT
to 6310'
(I used the remaining settings as per previous successful IR
connection - you can also enter or edit your ISP details here)

Now you should be ready to try to connect to your ISP
Select your e-mail or Internet application and connect
Palm shows 'Initializing..'
Phone shows 'Connect with Palm GC?' - press Accept

Ik hoop dat iedereen hier een beetje mee geholpen is.

Groetjes,
Erik

[jean-paul]

Ik zag gisteren overigens op de site van Palm UK dat er eindelijk drivers beschikbaar zijn voor de Nokia 6310 en de 6310i en nog een keur aan andere drivers voor mobiele telefoons.

[Susan]

Ik heb nu toch ook maar de nieuwste 6310i driver gedownload. Alles werkt bij mij: sms-en, bellen vanuit telefoonboek, etc), maar vreemd genoeg werkte dit ook zonder de driver...

Wat nog steeds niet lukt, is om een hele categorie adressen uit mijn Palm-adresboek via BT over te zenden naar de nokia telefoon. De Nokia krijgt alleen het eerste adres van de categorie binnen. De Nokia firmware versie is 4.07.

Is iemand er in geslaagd om via bt een hele categorie adressen over te sturen naar de Nokia telefoon?